An Unbiased View of dan wesson tactical reassembly

An Unbiased View of dan wesson tactical reassembly

Blog Article

I needed to consider this chance to Permit you to realize that I've up to date the serial selection search functionality in the Site Supporters segment. The record can now be limited to specific models which makes reviewing the information a lot easier. For those who have any inquiries remember to allow me to know!

I utilised a model 715 in this instance, Therefore the piece is cast to the side plate in the pic. I have seen a few previously model fifteen-two's where the halt is usually a pressed partially which includes fallen out, and gotten lost.

I acquired really Bored with dropping the cylinder halt on my initially 15-two and ultimately acquired six with the substitution cylinder stops. Less of a challenge to set up a completely new 1 than look for in the mud and crud on range to locate a dropped cylinder stop.

Concerning the 1973 & 1974 dates. To date, I truly feel These are extra synonymous than independent. But as normally with DW details, I hope much more evidence comes along sooner or later to verify this.

When Bob Serva acquired the Dan Wesson enterprise and moved it to Norwich NY, he retooled the shop with all new CNC machines and the 1st guns he manufactured had been marked “Initially issue” they went again to labeling the model fifteen and 715 dropping the -two.

Truly, the "Cylinder Halt" just isn't and by no means has been a named part on the Dan Wesson revolver. Early models, including early 15-two's, experienced a cylinder halt that was integral within the side plate, not a independent part, and it was not a press fit component. It had been a fairly fragile structure, and eventually DW reconfigured the aspect plate to possess a well supported cylinder halt, once again an integral Component of the sideplate.

Here is yet another, perhaps the rarest considered one of all, the EWK Clamp Mount w/picatinny rail. It seems a little funky Using the lengthy rail beneath a dan wesson grip checkering Fastfire.

Pistol Pacs ended up selected by a “P” then the model amount of the revolver frame, then the barrel shroud variety (blank) for normal, “V” for vent, “VH” for Vent Heavy

 My brother picked up a sweet model 15 porkchop a pair decades ago and never ever shot it. The male he acquired it fro. Reported that it was lacking the cylinder lock.

1966 – Dan resigns from S&W after an unsuccessful try to invest in plenty of shares to stop the Bangor Punta Corp from taking on.

I ultimately confident my brother to find the component and acquire it out shooting. So we just received it torn right down to put the cylinder lock in and there doesn't seem to be a spot for it. The one diagram I can find is for your 15-two. Can anybody support me out using this type of?

If you actually seem tough, you may be able to obtain considered one of the initial Buehler frame clamps. As opposed to the opposite mounts, this one replaces the rear sight and clamps around the topstrap. Rock reliable and makes it possible for barrel changes devoid of removing the scope.

The Model 11/twelve series highlighted an external barrel nut, “porkchop” style shrouds, and enormous, crudely manufactured sights, but provided the innovative interchangeable barrel/shroud design and style. Manufacturing quickly moved to your Dan Wesson owned facility within a transformed schoolhouse in Monson, MA. Dan Wesson Firearms capitalized around the exclusive interchangeable barrel style by offering Pistol Packs, packaged inside of a fitted case with many different barrel/shrouds and grips.

I already have one particular I got from Eric. The condition is I can't locate a superior diagram to indicate in which it goes around the model 15. Do that, not the best pic, but I believe it's the same as a 15